Triad's Mobile Diamond Quad Framer was designed for the on-site wall panel builder.

The same options are available on the mobile framer has the stationary table. However, there are several unique features. The mobile framer allows on-site framers many benefits of factory build framing on the work site. This allows quality square walls, precise nail placement, lower labor costs and higher production per man hour.

You no longer have to haul material over the road and set-up time is accomplished in minutes.

The framer has a telescoping hitch system that pivots up and out of the way. Four down riggers are dropped and locked into position during framing. When in transit, the down rigger legs are held up by pins. The frame is made of steel pipe to eliminate the frame flexing, if not on level ground.

*Tool Dollies shown are optional.

Specifications:

• Electrical Standard: 110 Volt, 1PH
• Air Requirements: 1/2 NPT, 10 CFM

Capabilities:

• Wall Height (standard): 6'9" to 10'3"
• Wall Height (optional): 6'9" to 12'3"
• Wall Lengths: 16' to 24'

*Specifications subject to change without notice.