< Framing Station

Framing Station

The GEN II Framer and Tool Dollies to make up the GEN II Framing Station.

About

Triad's Gen II Framing Station is made up of two basic components: the Gen II Framing Table and the Stud Stitcher Bridge or Tool Dollies (shown).

The Gen II Framing Table is custom built to make 12' to 80' long walls, with wall heights from 3'9" to 16'. Studs and plates are placed between our optional color-coded stud locators flippers and with just a push of a button, the width adjustment clamp is activated to clamp and square all components.

The Stud Stitcher then clamps the stud and four nails simultaneously, fastening the plates and stud.

Tool Dolly Options:

The Manual Tool Dolly is lined up on the stud and plate location by the operator. The operator activates the down clamp and pulls the trigger to fire both tools at the same time. When the operator wants to nail a 2x6 wall, the operator lifts up on the air assist tool dolly to nail 2x6.

The Trident Dolly allows the operator to set the nail pattern per each panel. Three nails in a 2x4, or four nails in a 2x6. The operator pushes a button that activates the down clamp and then pushes a button for the one gun to travel up to nail that pattern that the user set Nail pattern changes is done in seconds.

The operator then presses the optional automatic return and the bridge returns to its park position while the operator rolls the completed wall section to the next station in line.

Gen II Framing Table Stud Stitcher Bridge

Gen II Framing Table Specifications:

Specifications:

  • Electrical Standard: 100 Volts, 1 PH, 10 AMPS
  • Air Requirements: 1/2 NPT @ 100 PSI
  • Weight: 6000 lbs. (for 20'L)

Capabilities:

  • Custom built from 12' to 80' lengths of walls
  • Power width adjust for various wall lengths
  • Cast iron counter balanced stud locators
  • Tape track for placing window and door bridge
  • Includes rails to accommodate bridge
  • Continuous squaring lip for precision squaring
  • Select-o-matic squaring stops

Stud Stitcher Bridge Specifications:

Specifications:

  • Electrical Standard: 100 Volts, 1 PH, 5 AMPS
  • Air Requirements: 1/2 NPT @ 100 PSI
  • Weight: Approx. 5000 lbs.

Capabilities:

  • Custom built for 8' to 16' wall heights
  • Simple controls for one man operation
  • Nails 2x4 and 2x6 walls
  • Solid state sensors
  • Programmable logic controller controls all bridge functions
  • Horizontal clamping pressure at 750 lbs.
  • Vertical clamping pressure at 314 lbs.

*Specifications subject to change without notice.

Framing Station Options:

  • Laser pointer for safe, sure fastener locations
  • Automatic Panel Conveyor

Gen II Framing Table Options:

  • Knee Wall feature for short walls
  • Chain conveyor

Stud Stitcher Bridge Options:

  • Joystick Control
  • Auto Return
  • Laser Pointer

Often purchased with: